Dressmaker Trim Placement: Extend, Duplicate and Fix Clipping

Start with a short, visible border

Finish the garment construction and choose the edge you want to decorate. For a first attempt, use an edge that you can see clearly from the front. A sleeve cuff is a difficult place to learn: the developers specifically acknowledge that cuff placement remains frustrating even after the October improvements.

The following order is an editorial workflow based on the developer's documented controls. It helps isolate a bad placement without requiring you to rebuild an entire border.

1. Bring the target edge into view using the Build 443 camera controls.
2. Place a short section and inspect how it sits against the fabric.
3. Click its end node to select it. Click that node again when you want to extend the section.
4. Rotate the mannequin while placing trim to inspect the next stretch of the edge.
5. Adjust height, size or tilt before continuing around a complicated curve.
6. Use the duplicate button when a second piece should inherit the current height, size and tilt.

Choose Fast Trim Placement when repeated clicks are the problem

Build 443 adds a setting named Fast Trim Placement, intended to reduce clicking as well as speed up placement. Try it on a short section before decorating a whole hem. The announcement does not specify every input gesture in this mode, so follow the control hints in your installed build rather than assuming that an older tutorial's click sequence still applies.

Diagnose clipping one adjustment at a time

First rotate the mannequin and determine whether the trim is sinking into the dress or sitting too far above it. Change height in small increments, then inspect the tilt. A height adjustment moves the strip away from the surface; a tilt adjustment changes how it leans. Changing both together makes it harder to see which setting caused the improvement.

Negative trim heights are allowed in Build 443. That makes a negative value possible, but does not make it the right answer to every clipping problem. Test the visible result from the front, side and back before adding more trim.

Why an older dress may look different

The update changes trim placement and corrects default tilt offsets on certain trims, including ivory looping lace. Previously adjusted trim can therefore sit differently on an existing dress. If only an old border changed, inspect its tilt before blaming the underlying pattern or buying replacement material.

Check the result

The edge should remain visible as you orbit the mannequin, with no unexpected gaps or sections buried in the garment. If a cuff still fails, record the trim name, component and installed build. The developer asks players to report particularly broken older dresses; the announcement does not promise that every geometry issue is resolved.